WYROL B
Bearing Oil
Product Description
WYROL B Series are low staining bearing oils designed for use in aluminium cold rolling mills. They are formulated using select mineral base oils, a polymeric thickener and performance enhancing additives. If conventional oils contaminate aluminium roll oils as a result of leakage, staining problems are sometimes experienced on the finished aluminium after annealing. WYROL B oils reduce this problem, as the oil is removed from the aluminium piece during the annealing process. They have good anti-wear characteristics and protect heavily loaded bearings from damage and wear. WYROL B oils also exhibit good oxidation stability and corrosion prevention properties. Wyrol B conforms to U.S. FDA Regulation 21 CFR 178.3910(a) "Surface Lubricants used in the manufacture of metallic articles" is used for rolling of foil or sheet stock for food applications.. They therefore can be used as bearing fluids in aluminium rolling mills, which produce products such as foil for use as food packaging materials.
Features and Benefits
WYROL B oils are specifically designed to overcome the problems generated when conventional bearing lubricating oils contaminate the roll oils and result in finished product staining. They also provide very good lubrication characteristics to reduce wear and provide long service life.
WYROL B oils offer the following benefits:
- Very low staining properties improve the production of acceptable materials
- Reduced manpower costs for clean-up and lower scrapage rates
- Good anti-wear characteristics increase bearing life
- High oxidation stability increases oil service life
Applications
The leakage of aluminium roll oil into the bearing system results in the reduction of viscosity of the bearing oil. In such cases, WYROL B 2200, a special concentrate, may be used to adjust the viscosity of the roll oil-contaminated bearing oil to the required level.
- Bearing lubrication in aluminium rolling applications
- They are suitable for bath or mist lubrication systems
Specifications and Approvals
| Wyrol B meets or exceeds the requirements of: |
220 |
320 |
460 |
2200 |
| FDA 21 CFR 178.3910(a) |
X |
|
X |
X |
Typical Properties
| Wyrol B |
220 |
320 |
460 |
2200 |
| ISO Viscosity Grade |
220 |
320 |
460 |
2200 |
| Viscosity, ASTM D 445 |
|
|
|
|
| cSt @ 40ºC |
220 |
320 |
460 |
2200 |
| Viscosity Index, ASTM D 2270 |
160 |
160 |
160 |
160 |
| Ash, wt%, ASTM D 482 |
Max 0.005 |
Max 0.005 |
Max 0.005 |
Max 0.005 |
| Neutralization Number, mg KOH/g, ASTM D 974 |
Max 0.8 |
Max 0.8 |
Max 0.8 |
Max 0.8 |
| Pour Point, ºC, ASTM D 97 |
Max -12 |
Max -12 |
Max -12 |
Max -12 |
| Flash Point, ºC, ASTM D 93 |
Min 116 |
Min 116 |
Min 130 |
Min 130 |
Health and Safety
Based on available information, this product is not expected to produce adverse effects on health when used for the intended application and the recommendations provided in the Material Safety Data Sheet (MSDS) are followed. MSDS's are available upon request through your sales contract office, or via the Internet. This product should not be used for purposes other than its intended use. If disposing of used product, take care to protect the environment.
The Mobil logotype, the Pegasus design and Mobil Delvac are trademarks of Exxon Mobil Corporation, or one of its subsidiaries.
5-2011
Copyright © 2001-2013 Exxon Mobil Corporation. All rights reserved.
